OCR Gateway GCSE Chemistry chapter 5: C5: Monitoring and controlling chemical reactions MCQs with answers

By Team Megalecture · Updated 22 Nov 2026

56 exam-style questions on C5: Monitoring and controlling chemical reactions, each with the answer and a short explanation. Ten of them are below to try. The chapter test draws ten fresh questions each time and is marked the moment you finish, with your score by topic.

56 questions · 5 topics · 10 per test

Test this chapter freeAll OCR Gateway GCSE Chemistry chapters

What chapter 5 covers

Ten C5: Monitoring and controlling chemical reactions questions with answers

Try each one, then open the answer. These ten stay the same; the test draws new ones every time.

1. H2(g) + I2(g) ⇌ 2HI(g). What is the effect of increasing the pressure on the equilibrium amount of HI?

  1. A
    it increases, because the higher pressure favours the forward reaction
  2. B
    it doubles, because the pressure has doubled
  3. C
    it decreases, because the higher pressure pushes the reaction back to the reactants
  4. D
    it is unchanged, because both sides have the same number of gas molecules
Show answer

Answer: D. There are 2 gas molecules on each side, so pressure does not favour either direction. The rate still increases.

2. Heating blue hydrated copper(II) sulfate forms white anhydrous copper(II) sulfate and water. What happens when water is added back to the white solid?

  1. A
    it turns blue and the temperature rises
  2. B
    it stays white and the temperature rises
  3. C
    it turns green and the temperature falls
  4. D
    it turns blue and the temperature falls
Show answer

Answer: A. The forward reaction is endothermic, so the reverse is exothermic by the same amount: the solid turns blue again and warms up.

3. Hydrogen is made by CH4 + H2O → CO + 3H2. What is the atom economy for hydrogen?

  1. A
    82.4%
  2. B
    21.4%
  3. C
    17.6%
  4. D
    5.9%
Show answer

Answer: C. Total Mr of reactants = 16 + 18 = 34. Useful product 3H2 = 6. Atom economy = 6 ÷ 34 × 100 = 17.6%. 5.9% uses only one H2.

4. CuO + H2 → Cu + H2O. What is the theoretical mass of copper made from 7.95 g of copper(II) oxide?

  1. A
    12.7 g
  2. B
    7.95 g
  3. C
    6.35 g
  4. D
    3.18 g
Show answer

Answer: C. Mr CuO = 63.5 + 16 = 79.5, so 7.95 ÷ 79.5 = 0.100 mol. This gives 0.100 mol Cu: 0.100 × 63.5 = 6.35 g.

5. The concentration of a reactant in solution is doubled and the temperature is kept the same. Which statement is correct?

  1. A
    the frequency of collisions doubles, but the proportion of collisions with enough energy is unchanged
  2. B
    the frequency of collisions doubles, and the activation energy is halved
  3. C
    the frequency of collisions doubles, and twice as large a proportion of collisions are successful
  4. D
    the frequency of collisions is unchanged, but each particle has twice as much energy
Show answer

Answer: A. Twice as many particles in the same volume means about twice as many collisions per second. The energy of the particles and the activation energy depend on temperature and catalysts, not concentration, so the proportion of successful collisions stays the same.

6. A reaction has a theoretical yield of 25 g and a percentage yield of 60%. What mass of product was obtained?

  1. A
    10 g
  2. B
    15 g
  3. C
    41.7 g
  4. D
    60 g
Show answer

Answer: B. Actual yield = 60 ÷ 100 × 25 = 15 g. 41.7 g comes from 25 ÷ 0.60, which would be more than the maximum possible.

7. Why does increasing the pressure of a reacting gas mixture increase the rate?

  1. A
    the same particles are squeezed closer together, so collisions are more frequent
  2. B
    the particles are moving faster, so more collisions have the activation energy
  3. C
    the activation energy of the reaction is lowered at high pressure
  4. D
    the gas particles have more energy because the container is squashed
Show answer

Answer: A. Higher pressure is like higher concentration: more particles per unit volume means more frequent collisions. It does not change particle speed at a fixed temperature.

8. In the same reaction, ammonia is removed from the equilibrium mixture as it forms. What is the effect?

  1. A
    the position shifts left to replace the ammonia that was removed
  2. B
    more ammonia is made as the equilibrium shifts right
  3. C
    the concentration of hydrogen rises as the ammonia is removed
  4. D
    the reaction stops because there is no product to react back
Show answer

Answer: B. Removing a product lowers its concentration, so the equilibrium shifts right to replace it. Nitrogen and hydrogen are used up.

9. What is the percentage of nitrogen by mass in ammonium nitrate, NH4NO3? (Ar H = 1, N = 14, O = 16)

  1. A
    17.5%
  2. B
    28%
  3. C
    35%
  4. D
    50%
Show answer

Answer: C. Mr = 14 + (4 × 1) + 14 + (3 × 16) = 80. There are two nitrogen atoms, so the mass of nitrogen = 28. Percentage = 28 ÷ 80 × 100 = 35%. 17.5% counts only one nitrogen atom.

10. Why is the gradient of a product-against-time graph greatest at the start of a reaction?

  1. A
    the catalyst is most active at the start, before it is used up
  2. B
    the activation energy is lowest at the start of the reaction
  3. C
    the products that build up speed the reaction along as time goes on
  4. D
    the concentration of the reactant is highest, so collisions are most frequent
Show answer

Answer: D. As reactants are used up, their concentration falls, collisions become less frequent and the rate (gradient) decreases. A catalyst is not used up and the activation energy does not change during a reaction.

Start the chapter testAbout the OCR Gateway GCSE Chemistry test

Read the notes for this chapter

Ways to practise this chapter

C5: Monitoring and controlling chemical reactions: questions students ask

How many C5: Monitoring and controlling chemical reactions MCQs are there?

56, each with the answer and a short explanation, across 5 topics: Yield and atom economy, Calculating and measuring rates of reaction, Factors affecting rate, collision theory and catalysts, Reversible reactions and dynamic equilibrium, The Haber process and NPK fertilisers. Every chapter test draws ten of them, so you can take it many times.

Is the OCR Gateway GCSE Chemistry chapter 5 test free?

Yes. The test, the answers and the explanations are free and need no sign-up. Sign in only if you want your scores kept across devices.

How is the chapter test marked?

The moment you press Finish: your score, the right answer and an explanation for every question, and the ones you got wrong saved in My mistakes to retry.

Keep going

← Chapter 4: C4: Predicting and identifying reactions and productsChapter 6: C6: Global challenges →All chaptersStuck? Ask a question