Edexcel IGCSE Physics chapter 2: 2: Electricity MCQs with answers
By Team Megalecture · Updated 22 Nov 2026
91 exam-style questions on 2: Electricity, each with the answer and a short explanation. Ten of them are below to try. The chapter test draws ten fresh questions each time and is marked the moment you finish, with your score by topic.
Try each one, then open the answer. These ten stay the same; the test draws new ones every time.
1. Resistors of 4.0 Ω and 12 Ω are connected in parallel. The current in the 4.0 Ω resistor is 0.90 A. What is the current in the 12 Ω resistor?
A
0.30 A
B
0.90 A
C
1.2 A
D
2.7 A
Show answer
Answer: A. Parallel resistors have the same p.d.: V = 0.90 × 4.0 = 3.6 V. Current in 12 Ω = 3.6 ÷ 12 = 0.30 A. The larger resistor takes the smaller current; 2.7 A has the ratio upside down.
2. Two identical cells, each of e.m.f. 1.5 V, are connected in parallel. This pair is then connected in series with a third identical cell, all facing the same way. What is the total e.m.f.?
A
1.5 V
B
2.25 V
C
3.0 V
D
4.5 V
Show answer
Answer: C. Identical cells in parallel have the e.m.f. of one cell, 1.5 V. Adding one more cell in series gives 1.5 + 1.5 = 3.0 V. 4.5 V treats all three as in series; 2.25 V wrongly halves the parallel pair.
3. A cell, a switch and a lamp are in series. A student wrongly connects an ammeter in parallel with the lamp and closes the switch. What happens?
A
the lamp goes out or is very dim and the ammeter shows a large current
B
the lamp lights normally and the ammeter reads zero
C
the lamp becomes brighter and the ammeter reads zero
D
the lamp lights normally and the ammeter shows the lamp current
Show answer
Answer: A. An ammeter has a very low resistance, so in parallel it short-circuits the lamp: almost all the current goes through the ammeter, which may be damaged. Ammeters must be in series.
4. A student has several 5.0 Ω resistors. How many must be connected in series to give a combined resistance of 35 Ω?
A
4
B
5
C
6
D
7
Show answer
Answer: D. In series the resistances add: 35 ÷ 5.0 = 7 resistors.
5. Which list contains only electrical insulators?
A
rubber, dry wood and glass
B
copper, graphite and steel
C
aluminium, plastic and glass
D
steel, rubber and silver
Show answer
Answer: A. Rubber, dry wood and glass are insulators. Metals (copper, steel, aluminium, silver) and graphite are conductors.
6. As the current through a filament lamp increases, its resistance
A
decreases, because the filament gets hotter
B
increases, because the filament gets hotter
C
stays constant, because it obeys Ohm's law
D
becomes zero
Show answer
Answer: B. The filament heats up; the metal ions vibrate more and impede the electrons, so resistance rises. This is why the I–V graph of a lamp curves.
7. A lamp and a 30 Ω resistor are connected in series to a 12 V battery. A voltmeter across the lamp reads 4.5 V. What is the current in the lamp?
A
0.15 A
B
0.25 A
C
0.40 A
D
0.55 A
Show answer
Answer: B. The p.d.s in series add to 12 V, so the resistor has 12 − 4.5 = 7.5 V across it and I = 7.5 ÷ 30 = 0.25 A. The current is the same in the lamp. 0.15 A uses 4.5 V across the resistor; 0.40 A uses all 12 V.
8. A variable potential divider (a resistor with a sliding contact) is connected across a 6.0 V supply. The output is taken between the slider and the negative end. The slider is moved slowly from the negative end to the positive end. How does the output p.d. change?
A
it falls steadily from 6.0 V to 0 V
B
it stays at 6.0 V
C
it rises steadily from 0 V to 6.0 V
D
it rises from 0 V to 3.0 V and then falls back to 0 V
Show answer
Answer: C. With the slider at the negative end the output is across none of the resistance (0 V); at the positive end it is across all of it (6.0 V). In between it takes a share in proportion to the length, so it rises steadily.
9. An NTC thermistor is placed in a beaker of water that is slowly heated. What happens to the resistance of the thermistor?
A
it decreases
B
it increases
C
it stays the same
D
it falls to zero and stays there
Show answer
Answer: A. NTC stands for negative temperature coefficient: the resistance of the thermistor falls as its temperature rises, smoothly rather than dropping to zero.
10. A lamp takes a current of 0.50 A from a 230 V supply for 2.0 minutes. How much energy does it transfer?
A
230 J
B
1.38 kJ
C
13.8 kJ
D
828 kJ
Show answer
Answer: C. E = IVt = 0.50 × 230 × 120 s = 13 800 J = 13.8 kJ. 230 J comes from leaving the time in minutes; 828 kJ from treating 2.0 minutes as 2.0 hours.
Chapter test. Ten questions from 2: Electricity, drawn fresh each time, about ten minutes.
Practice mode. The right answer and the explanation after every question, with no clock. Exam mode keeps the marks until the end and runs a timer.
Hints. One tap for a nudge, a second to remove two wrong options.
My mistakes. Every question you get wrong is kept, and leaves the list once you get it right.
2: Electricity: questions students ask
How many 2: Electricity MCQs are there?
91, each with the answer and a short explanation, across 3 topics: Electrical quantities, Electric circuits, Practical electricity. Every chapter test draws ten of them, so you can take it many times.
Is the Edexcel IGCSE Physics chapter 2 test free?
Yes. The test, the answers and the explanations are free and need no sign-up. Sign in only if you want your scores kept across devices.
How is the chapter test marked?
The moment you press Finish: your score, the right answer and an explanation for every question, and the ones you got wrong saved in My mistakes to retry.